1. Pre-formed aluminium two piece ridge flashing
2. Extruded aluminium ridge member with pre-formed aluminium internal tray sections
NOTE. Hip section through is similar to Ridge section through.

On larger lanterns, Stainless steel tension wires may be required for the integrity of the skylight

5. Extruded aluminium two piece cill member

SECTION THROUGH GLAZING BAR

7. Extruded aluminium weather bar

 

 

3. Glazing Bar section
4. Double glazed unit
PLAN ON CORNER POSITION OF LANTERN
SECTION THROUGH LANTERN UPSTAND
KEY

Our Hipped Lights are available both as skylights using our cill member and as traditional Lantern Lights, which incorporate our aluminium vertical upstand frames.

All lights can be manufactured to any reasonable size and at pitches, which increment at 5° intervals from 15° to 45°. Pitches outside this range incur a surcharge.

All our Skylights and Lanterns are fully assembled in our factory during manufacture to ensure a perfect fit with no site cutting.

 

 

 

 

 

 

9. Snap-in aluminium bead section with EPDM gasket seals

12. Finished structural curb by others

11. Pre-formed aluminium cill flashing

10. Extruded aluminium RHS corner post

SPG Office Roof
Domestic Property, Felixkirk
SPG Office Roof

Hipped Lantern Skylights

 

Skylights are manufactured in 5° increments from 15° to 45°

Our Technical department is always available to answer your queries and to offer our expert advice
The Standard Patent Glazing Co. Ltd Flagship House, Forge Lane, Dewsbury, West Yorkshire, WF12 9EL
Tel 01924 461213 Fax 01924 458083 mail enquiries@patent-glazing.com www.patent-glazing.com